19
A
D
V
A
N
C
ED
S
TEP
5 - S
ELECT
N
UMBER
OF
S
EGMENTS
The display should be fl ashing “SEG” alternately with the current segment setting.
Press
or to select the number of segment you wish to use in your program. You
may choose a value of up to 8 segments
Press
to enter the segment number.
S
TEP
6 - E
NTER
R
ATE
, T
EMPERATURE
,
AND
H
OLD
T
IME
F
OR
E
ACH
S
EGMENT
Rate
The display should now be fl ashing “rA 1” alternately with the value that is currently
entered for the temperature rate for segment 1. To change this value
Press
or to
select the desired temperature.
Press
to enter that value.
Temperature
The display should now be fl ashing “°F 1” alternately with the value that is currently
entered for the temperature value for segment 1. To change this value
Press
or
to select the desired temperature.
Press
to enter that value.
Hold
The display should now be fl ashing “°HLd 1” alternately with the value that is currently
entered for the Hold time for segment 1. To change this value
Press
or to select
the desired Hold time.
Press
to enter that value.
S
TEP
7 - S
TART
If your program has more than one segment repeat these steps for each segment. When
the fi nal segment information has been entered the display will read “rEDI”. This indi-
cates the program is “ready” to run.
Press
to start the program. When the program
is started the display will read “ON” for a few seconds and then display the current kiln
temperature. You should see the temperature begin to rise after a few seconds.
Review
At this time it may be a good idea to Review the program to make sure it was entered
correctly. To do this press . The display will step through the information entered
for each segment. If this information is not correct stop the fi ring and reprogram the
kiln.
When The Firing is Complete
When The Firing is Complete
When the program is complete the controller will beep for 15 seconds and fl ash “CPLt”
alternately with the current temperature of the kiln and the amount of time it took to fi re
the program.
Important - Depending on the program the kiln could still be very hot.
Be sure to check the internal temperature of the kiln before touching the kiln or open-
ing the lid. We recommend waiting until the kiln temperature is below 100 ˚F (
˚˚ 38
F (
F ( ˚C).
A
DVANCED
P
ROGRAMING
