20 | ANOA EX+ User Manual
Copyright owned by Skutis Corporation Pte. Ltd.
(2) Detailed LCD Settings/ P Settings
Mode
Description
Mode
Display Values and Settings
TRIP
Current mileage (Press and hold
the mode button to set “0”)
P0
10
– wheel diameter (don’t change!)
ODO
Total mileage
P1
45.0
– cut-off voltage (don’t change!)
CHA
Not used
P2
15
– ferrite magnet (don’t change!)
VOL
Current voltage (Volt)
P3
0
– Hall sensor (don’t change!)
DST
Not used
P4
Speed display: Km/h (0), mp/h (1)
TIME 1
Elapsed time, since dashboard
was switched on
P5
Start mode: Accelerator start (0), start
after kicking/ back wheel spins (1)
TIME 2
Not used
P6
Cruising mode (auto riding): Off (0),
On (1)
Note:
The voltage displayed in VOL mode
has about 1V to 2V difference from
the actual battery voltage.
P7
Start speed: Power start (0), slow
start (1)
P8
Max. speed setting: 1 to 100%
P9
Electric brake power: Off (0), medium
(1), hard (2)
(3) Cruising Function
The cruise
control function allows you
to
maintain
the
riding
speed
automatically. This is convenient for
the rider for long distances and has the
advantage
of
saving
battery
consumption.
*
Starting the cruise function
a. Activate the cruising mode through
the P settings before riding, as
explained above.
b. If the throttle is kept at the same
acceleration for about 6 seconds,
the
cruise
mode
will
start
automatically.
*
Deactivating the cruising function
When you use the brake while the
cruising mode is running, the cruising
mode will be automatically deactivated.
*
Caution while using the cruising
function
For your safety, be sure to travel in a
position where the brake can be
applied
immediately
in
order
to
respond to any unforeseen incidents.
(4) Adjusting the Intensity of the
Electric Brake
The ANOA EX+ is equipped with a
physical brake for the front and rear
wheel, which can be activated by pulling
the physical brake levers on the handle
bar. Additionally, the electric rear brake
can be activated in the P9 LCD settings.
If “0” is selected, the electric brake is off,
“1” will assist with medium intensity and
“2” with strong intensity.
*
Do not operate the electric brake
if your battery is fully charged
For your safety and to enhance the
lifetime
of
your
battery,
it
is
recommended that you do not use the
electric brake with a fully charged
battery. Only use the electric brake,
after more than 5% of the battery
capacity was used.
