SKUTCH BA-1000, Technical Reference Manual, Page: 12 / 37

Version 3.12 Page 12
choose. To access this feature, press then release
1 1 1 1
when it shows the following:
0-Entry> 00000
---- #=Dial ----
This will clear the entry position, as follows:
0-Entry>
---- #=Dial ----
Now enter the position of the phone number
you want to start dialing with, followed by
#
# #
#
.
The dialing will start from the position you enter and
continue dialing to the end of the file.
! No Answer Redials
When the system has dialed the entire file, it
will start dialing at the beginning; dialing only NO
ANSWER and BUSY calls. The NO ANSWER
redial feature is controlled by the REDIALS setting
in the SYSTEM SETUP (see Redials ).
! 6pm Redials
The system now has the ability to stop it’s
current dialing at 6pm and begin calling, from the
start of the file, all the No Answers and Busies. This
feature is off by default and can be enabled by
turning
6pm Redials on in 0 System Setup .
! 15 Minute Busy Redials
When busy numbers are encountered, the
system will log them into a busy re-dial table and,
after 15 minutes, call them at the next opportunity.
If the system cannot get through to a busy number
after 8 consecutive tries, it will remove the entry
from the busy re-dial table. You can now disable
this feature through
Busy Disable in 0 System
Setup .
! Do Not Dial List
During a dialing session, the system will not
dial any phone numbers that match those entered
into the
DO NOT DIAL list.
!
Dialing
On entering this mode, if you have not recorded
an outgoing message Prompt, the system will beep 4
times and show the following before returning to
MENU :
** No message **
prompt recorded!
If you haven’t entered any phone numbers to
dial, the system will beep 4 times and show the
following before returning to
MENU :
No numbers found
in current file!
Before the system calls each number, it will
search for the next callable number and display the
following during the search:
0-Entry 00000
Finding Entry
When the system finds a good entry, it tries to
grab the line. If the line is in use, the system will
wait for the line to become available and it will show
the following:
* Testing Line *
* Line In Use! *
Once the line is free, the system will search for
a dial tone, and display the following:
Dial Tone Search
The system must receive 1 second of solid dial
tone before it will start dialing. If it does not detect
dial tone within 6 seconds the system will release the
line and display the following:
- No Dial Tone -
After 6 seconds, the system will repeat the
process until it gets dial tone, then it will dial the
entry. After the system finishes the call, the system
will release the line and display the result for the
Dial Pause number of seconds, as follows:
0-Entry> 00000 C
----- Lead -----
Pause During Dialing
You can pause the dialing by pressing, and
holding down, the # button while it shows the
following: