5
1
Charge the BT LINK’s internal battery
2
Pair the BT LINK with your Bluetooth phone.
3
Attach the BT LINK to your helmet or headphones.
4
Attach a music source to your BT LINK.
Charging the BT LINK’s Internal Battery
First-time Use – Before you can use your BT LINK, you need to charge its internal battery fully for
at least two hours. Perform these steps to charge your BT LINK:
1
Plug the included 2.0 USB cable into a high-power USB port on your computer
Note:
The USB port on your keyboard doesn’t provide enough power. You must
connect BT LINK to a USB port on you computer.
2
Connect the other end into your BT LINK
<< ILLUSTRATION >>
While charging, the LED will
steady on
red. When charge is completed, the
indicator will turn off.
3
When charging completes (indicators off), unplug the cord from the computer, and
your BT LINK.
Note:
•
Low voltage indication: 2 tones from the headset every 30 seconds and LED will flash red.
It is recommended to charge the headset immediately after low voltage indication to
prolong the durability of the battery and standby time. Under low voltage, if the battery is
not charged within approximately 30 seconds, the headset will be powered off.
•
Charging indication will be delayed for a few minutes if the headset has not been used for
a long time or the battery is drained.
Pairing Your BT LINK and Bluetooth Phone
You must pair (link) your BT LINK and your Bluetooth-enabled phone before you can make or
receive calls. “Pairing” links two Bluetooth equipped devices, and allows your phone to remember
your BT LINK’s unique ID. After your BT LINK and phone are paired, your BT LINK automatically
connects to your phone when you turn it on. Perform these steps to pair (link) your phone and BT
LINK:
1
Turn on the Bluetooth power on your phone. Bluetooth power option may be
OFF
by
default. Bluetooth power must be
ON
to search for devices. Refer to your phone’s
user guide.
2
Put your BT LINK into pairing mode
With your BT LINK off, press and hold the Logo Button until the LED alternately
flashes blue and red (about 5 seconds).
3
Set your phone to look for your BT LINK, and select “
BTLink-SK/Giro
” from the
device list.
Press OK and YES to pair (link) the device. Enter the passkey “0000” and press OK.
Your BT LINK’s ID is now stored in your phone’s memory.
When your BT LINK is successfully paired with your phone the LED will flash blue 5
times followed by a long tone.
Note:
.If the pairing cannot be completed within 2 minutes while the pairing mode is
activated, the headset will enter standby mode, Please repeat the above pairing
procedures.
