SKS-Kinkel Elektronik GmbH
EN
300101 Table installation kit
Support-Hotline: +49 (0) 2661 98088 112
- 21 -
Version: 1.1
E-Mail: [email protected]
Document art. no. 97011101
3.2.2
Mounting
Using the screws attach the supporting frame of the indoor station
to the table installation kit. Please use the fastening holes provided
on the upper and lower part on the table installation kit.
Pay particular attention to the installation cable when
mounting the supporting frame!
Connect the terminals to the previously installed cable. The
terminals are located at the back of the indoor station.
The pre-assembled cables are then connected to the indoor
station.
To avoid errors when connecting cables please use the
planning guide or the wiring diagram. Pay particular attention
to the setting of the DIP switch when the indoor station is
replaced!
Set the SKS bus call address at the DIP switch on the back of the
indoor station. Each address is assigned to a bell button at the
door station. The SKS bus table of call addresses can be found in
the appendix.
