SKS-Kinkel Elektronik GmbH
EN
300098 BUS bell
Support-Hotline: +49 (0) 2661 98088 112
- 15 -
Version: 1.1
E-Mail: [email protected]
Dokument Art. No. 97010601
Set the SKS bus call address at the DIP switch on the back of the
300098 BUS bell. Each address is assigned to a bell button at the
door station. The SKS bus table of call addresses can be found in the
appendix.
Pay particular attention to the setting of the DIP switch when the
300098 BUS bell is replaced!
Remount the 300098 BUS bell in the upper part of the supporting
frame.
Subsequently press the 300098 BUS bell into the frame until it clicks
into place.
3.3
Surface mounting
Using the screws attach the supporting frame of the 300098 BUS bell
to the wall. Please use the fastening holes provided on the supporting
frame.
Pay particular attention to the installation cable when mounting
the supporting frame!
Connect the terminals to the previously installed cable. The terminals
are located at the back of the 300098 BUS bell.
The pre-assembled cables are then connected to the 300098 BUS
bell.
To avoid errors when connecting cables please use the planning
guide or the wiring diagram.