SKS-Kinkel Elektronik GmbH
EN
300090 Video compact power supply
Support-Hotline: +49 (0) 2661-98088-112
- 11 -
Version: 1.0
E-Mail: [email protected]
Document art. no. 97009500
4.1
Störung- LED
Depending on the fault that has occurred, the video compact power supply 300090 will generate a diagnostic error
code. This is indicated by the Störung- LED.
In case of an error the Störung- LED will flash about 1 time per second. Once the LED has lit up the respective
number of times it will stay off for 5 seconds. After that it will come on again and flash accordingly. The table below
shows the number of times the Störung- LED will flash to indicate the respective fault.
LED flashes
Definition
1x
Minimum input voltage not reached by far
2x
Protection switching transistor (+22 Output)
3x
Capacity of heat dissipation exceeded
4x
Total current briefly too high
5x
Total current too high for a longer period
6x
Excess current in camera output
7x
12V-output voltage too low
8x
12V-output excess current
The LED indicates the most recently recognized fault for one day. Once a fault has been detected, the outputs are
shut down for 30 seconds. If a fault occurs repeatedly, there will be a shut-off of 6 minutes.
4.2
Betrieb / Power LED
The Betrieb / Power- LED indicate the operation mode of the video compact power supply 300090. The table below
shows the different stages.
Status LED
Bedeutung
LED on
Operative
LED flashes
Low input voltage
LED off
Outputs switched off
