Removing/stowing wheel in vehicles with sound system
Fig. 310
Take out the wheel
The spare wheel is located in a well under the floor covering in the luggage
compartment and is fixed in place with a fastening screw.
Take out the wheel
›
Lift up the floor in the luggage compartment.
›
Press the latch
A
on the holder in the direction of the arrow
1
.
›
Press the latch in the direction of arrow
2
and pull out the holder in the di-
rection of arrow
3
.
›
Remove the locking screw in the direction of arrow
4
.
›
Remove the bass loudspeaker.
›
Remove the wheel.
Store wheel away
›
Place the wheel into the wheel well with the wheel rim pointing downward.
›
Insert the bass loudspeaker.
›
Tighten the locking screw in the opposite direction of arrow
4
until it stops
›
Insert the connector in the bass loudspeaker.
›
Secure the latch
A
in the opposite direction to arrow
1
.
›
Fold back the floor in the luggage compartment.
Full wheel trim
Removing the trim
›
Hang the clamps for removing the full wheel trims at the edge of one of the
ventilation openings in the full wheel trim.
›
Push the wheel wrench through the clamp, support on the tyre and pull off
the wheel trim.
Installing the trim
›
Press the wheel trim onto the wheel rim at the designated valve opening.
›
Then press the trim into the wheel rim until its entire circumference locks
correctly in place.
The back of the wheel trim supplied by the factory or from the ŠKODA Origi-
nal Accessories shows the position for the anti-theft wheel bolt. When using
the anti-theft wheel bolt, this is to be fitted in this point
»
.
WARNING
We recommend that you use hub caps from ŠKODA Original Accessories.
A sufficient air supply may not be able to be guaranteed with other wheel
trims to cool the braking system – Otherwise there is a risk of an accident.
CAUTION
■
If the wheel trim is set outside the position marked for the anti-theft wheel
bolt, there is a risk of damaging the wheel trim.
■
Use only manual pressure and do not hit the full wheel trim – otherwise there
is a risk of damaging the trim.
Note
We recommend that you use hub caps from ŠKODA Original Accessories.
Wheel bolts
Fig. 311
Remove the cap
›
To remove the cap, insert the extraction pliers up to the stop on the cap and
pull this in the direction of the arrow
.
›
To install, insert the cap up to the stop on the wheel bolt.
275
Emergency equipment and self-help
Summary of Contents for KAROQ 2017
