10
ENVIRONMENT
• Do not dispose of electric tools,
batteries,accessories and packaging together
with household waste material. The electric tools,
accessories and packaging should be sorted for
environmental-friendly recycling.
! prior to disposal protect battery terminals with
heavy tape to prevent short-circuit
#alleen_spaans#
MAINTENANCE / SERVICE
• This tool is not intended for professional use
• Always switch off the tool, remove battery pack, and
ensure that all moving parts have come to a complete
standstill
• Always keep tool clean (especially ventilation slots
1
)
-
clean the tool with a damp cloth (do not use cleaning
agents or solvents)
-
clean line cutting blade
1
and cutting guard
1
after
each use
-
clean ventilation slots
1
regularly with a brush or
compressed air
• Regularly check the condition of the cutting head and the
tightness of nuts, bolts and screws
• Regularly check for worn or damaged components and
have them repaired/replaced when necessary
• Storage
Storage method 1
a
-
securely mount storage rail on the wall with 2 screws
(not supplied) and horizontally leveled
-
attach the storage adapter and move it against the
mounting base of the storage rail
-
store the tool with the storage hole in the handle over
the tip of the storage adapter
Storage method 2
y
-
use pivot position 1 and let the tool stand by itself on
the ground
TROUBLESHOOTING
• The following listing shows problem symptoms, possible
causes and corrective actions (if these do not identify
and correct the problem, contact your dealer or service
station)
! in case of electrical or mechanical malfunction,
immediately switch off the tool and remove battery
Tool does not operate
-
empty battery -> charge battery
-
hot battery -> let battery cool down
-
internal fault -> contact dealer/service station
Tool operates intermittently
-
internal wiring defective -> contact dealer/service
station
-
on/off switch defective -> contact dealer/service station
Tool vibrates abnormally
-
grass too high -> cut in stages
Tool does not cut
-
line too short/broken off -> feed the line manually
Line cannot be fed
-
spool empty -> replace spool
-
line entangled inside spool -> inspect spool; rewind if
necessary
Line is not cut off to correct length -> remove cover from
cutting blade
Line keeps breaking
-
line entangled inside spool -> inspect spool; rewind if
necessary
-
trimmer incorrectly used -> only trim with the tip of the
line; avoid stones, walls and other hard objects; feed
the line regularly
