Skil 3100-10, Operating/Safety Instructions Manual

Page: 11 / 16

11.
FIG. 3
Y
Attaching Sander Insert
The following Skil Sander Models may be used with the sander
insert: Model 7500.
BEFORE USING THE SANDER: Read the
instruction manual that came with the sander.
From among the loose parts, locate the following hardware (Fig. 1).
Hardware Kit Sander Insert
Item Description Quantity
S1 Sander Insert 1
S2 Sander Bracket Right 1
S3 Sander Bracket Front 1
S4 Sander Bracket Left 1
S5 Hex-head Screw (long) 2
S6 Wing Nut 10
S7 Washer 10
S8 Retaining Bracket 1
S9 Sander Fence 1
S10 Wear Bracket 2
S11 Hex-Head Screw (short) 8
1. Make sure the sander switch is in the OFF position and the cord
is unplugged.
2. Install sanding belt per the sander’s original instruction manual.
3. Attach sander wear brackets
S10
to insert. (Fig. 1)
4. Fasten the right and left sander brackets S2 , S4 to the insert
using 4 hex-head-screws S11 , 4 washers S7 and 4 wing nuts S6
as shown. (Fig. 1)
5. Insert the sander, making sure that the tabs
YY
on the flat
brackets engage with the four slots
XX
on the sides of the sander
(Fig. 2).
6. Install the front bracket S3 using 2 hex-head screws S11 , 2
washers S7 and 2 wing nuts S6 as shown. Be sure the sander is
fimly installed and cannot work its way loose.
7. Attach retaining bracket
S8
onto bottom of insert using hex-head
screws
S11
, washers
S7
and wing nuts
S6
as shown.
8. Lift the red latch lever Y located at front of the table opening and
remove blank insert (Fig. 3).
9. Slip tabs X on edge of insert into rear of table opening. (Fig. 4)
10. Lower the front edge of insert S1 into table and lower the red
latch lever Y (Fig. 4 & 5).
11. Install the fence
S9
using the (2) Wing nuts
S6
, (2) Hex-head
screws
S5
and (2) Washers
S7
(Fig. 1)
12. Lock the sander switch to the ON position.
13. Make sure the main table power switch is in the OFF position.
14. Insert the sander electrical plug into the accessory power outlet.
15. See the section on “Operation of the Accessory Power Outlet”.
16. Operate the sander in accordance with the sections entitled
“Sander Safety” and “Operation of a Sander with the Sander
Insert” in this manual.
1 2
x5
1
2
S9
S11
S8
S7
S6
S5
S11
S1
S10
S3
S6
S7
S2
S4
XX
YY
S4
FIG. 1
FIG. 2
FIG. 4
WARNING
!
(Tool Not Included) / (Outil non joint) / (Herramienta no incluida)
S6
S7