Ski-Doo MX Z X 600 RS, Operator'S Manual

Page: 53 / 127

CONTROLS, INSTRUMENTS AND EQUIPMENT
Remove the tether cord cap.
Open engine compartment LH side
panel, refer to
CONTROLS, INSTRU-
MENTS AND EQUIPMENT .
Remove retaining pin.
mmo2008-007-016_a
1. Retaining pin
Lift rear portion of guard then release
from upper retaining pin.
Release guard from the front tabs by
pivoting the guard outwards.
Drive Belt Guard Installation
When reinstalling belt guard, position
its cutaway toward front of snowmo-
bile.
Place the front LH slot of the guard
over the longest tab.
Pivot the guard inward to engage the
shortest tab in the RH slot.
mmo2009-003-010_a
1. Tabs
Position the grommet over the retain-
ing rod. It may be necessary to slightly
lift the console to make room.
mmo2009-003-011_a
1. Retaining rod
Position rear portion of belt guard over
retainer and secure it using retaining
pin.
mmo2008-007-016_a
1. Retaining pin
16) Spare Drive Belt Holder
A spare drive belt can be stored in
holder.
NOTE: Spare drive belt is not supplied
with the snowmobile.
Properly install spare belt and secure
with Velcro strap as shown.
NOTICE
To avoid damages to the
drive belt, ensure that belt does not
come in contact with tuned pipe
when installed in its support.
_______________
51