Ski-Doo 2000 Mach 1, Operator'S Manual

Page: 66 / 123

64
STARTING PROCEDURE
• Re-check throttle control lever operation.
• Ensure that the emergency cut-out switch is in the ON position.
• Ensure the tether cut-out cap is in position and that the cord is
attached to your clothing.
Initial Cold Starting
All Models Except Grand Touring 700/SE
NOTE: Do not operate the throttle lever during starting.
Set the choke lever to the second position.
Grasp starter handle firmly and crank engine or use electric starter
on so equipped models.
After the engine is started, close off choke.
If speed is dropping below 1500 RPM, set choke lever to first position
for 2 seconds then close off choke.
0. OFF
1. Position 1
2. Position 2
Grand Touring 700/SE
These vehicles are equipped with a DPM (Digital Performance Man-
agement) system that takes care of carburetor calibration according
to altitude and temperature. The only operation to be done is starting
the engine.
However, in very cold temperature, it may be necessary to use the
emergency choke. Operation of this choke is the same as described
above.
0
1
2
A06H1KB
Mmo2000-004b.fm Page 64 Monday, May 10, 1999 2:43 PM