SKF Multilog On
-Line System IMx-S
1 - 1
User Manual
1
Introduction
Important Messages
The following messages are important information which require special care in order
to have a safe and reliable IMx-S system.
Important messages, instructions and information in this manual must be
carefully followed. Otherwise, harm might occur to equipment and/or personnel.
In order to fulfill fire enclosure requirements the following must be ensured:
-
The cabinet must always be mounted using all four supplied mounting
brackets.
-
All unused cable ways must be closed with the supplied blind plugs.
-
All cable glands and blind plugs must be made of material with fire protection
V-1 or better.
Important messages related to mains power (see Mains Power section as well):
-
In some countries, you have to be certified in order to connect an IMx-S to the
power grid
-
Make sure that the power is disconnected before the installation.
-
Mains cable must be properly fixed with a cable gland to prevent the cord from
strain, twist or move. See Cable Glands section as well.
-
In order to prevent a hazardous event, mains cable neutral (N) and line (L1)
wires must be secured together with a cable tie (for example, a nylon cable tie
CV-100K) close to the mains power connector.
-
For permanently connected IMx-S, an external all pole power switch must be
installed in order to be able to disconnect the IMx-S from the mains power
grid. The switch must be labeled "IMx-S” or similar. On/Off position must be
clearly marked. The switch must be located close to the IMx-S, within
operator's easy reach.
IMx-S unit contains circuit boards that are static sensitive. Therefore, use
appropriate precautions to prevent ElectroStatic Discharge (ESD) when handling
circuit boards.
