QuickCollect CMDT 391 / CMDT 391-Ex
2 - 7
User Manual
–
Revision B
Note the following:
•
It is not possible to take a measurement using the internal sensor whilst a cable
is attached to this connector, as the internal sensor is disconnected and
therefore inoperable. This applies even if no external sensor is attached to that
cable.
•
When using an external sensor cable the temperature measurement is similarly
unavailable.
•
Battery life will be reduced as the QuickCollect sensor is powering the external
sensor.
•
Never carry the QuickCollect sensor by the attached cable.
The following status conditions may apply when using an external sensor/cable
combination:
1.
No cable plugged in - this is the expected status when using the internal sensor
to acquire data and not having any sort of cable attached.
2.
Ca le plugged i a d o error dete ted
- this is the expected status when using
an external sensor to acquire data. It indicates the external sensor cable is
attached and no error condition detected.
3.
Cable plugged in and a short circuit error detected.
4.
Cable plugged in and an open circuit error detected.
5.
Cable plugged in, but no sensor attached.
Notes:
Status conditions 3, 4 an
d are o sidered error o ditio s a d are sig alled the All
-
purpose check LED flashing alternate amber and red, approximately 2 times a second
It is not possible to take a measurement when an error condition is detected.
At present, it is not possible to distinguish between the open circuit error condition (4)
a d the o se sor atta hed o ditio .
Calibration, Repair and Disposal
It is recommended that the QuickCollect sensor be calibrated every 24 months, with the
first calibration due 24 months from the first date of in-service, use.
SKF can provide calibration and if needed repair/replacement of QuickCollect sensors.
Electrical waste and electrical equipment should be recycled as specified by the WEEE-
directive and not be placed in the general refuse. Product should be sent to an approved
recycling centre for safe recycling, recovery, reuse or returned to SKF.
