5
（9） Before operating the operator shall conduct a comprehensive safety inspection,
confirm the safety guards and safety devices of the machine before starting the
machine to normal after all.
（10） After machine maintenance, to ensure the safety devices and protective cover,
complete and accurate installation in the original location.
（11） Only off the power, gas supply, all the moving parts of the machine is completely
stopped and disconnect the power before they can repair, maintenance,
replacement and cleaning machine debugging.
（12） Replacement parts must use original parts, otherwise it will cause danger or
damage to the machine.
（13） In the case of the machine must be running unattended operator when the operator
leaves the machine, you must turn off the power.
（14） Always check all power lines and ground lines, ensure that the machine's
electrical system has good insulation and grounded. Not use defective wires.
（15） Prohibiting the use in wet or explosive environment, or they may cause serious
danger.
（16） Keeping the work environment clean, provide adequate lighting.
（17） Prohibit children and visitors close to the machine, the operator at least 18
years of age have the ability to predict the presence of dangerous machines.
（18） Do not drink after fatigue and have a hypnotic effect and taking similar drugs
operate the machine.
（19） The operator must not wear loose clothing, not wearing a tie, gloves or jewelry
(such as rings, bracelets, watches, etc.).
（20） Long hair must be wrapped with a wig and reliable, to prevent hair caught in
the machine inside.
(21) When operating the machine is recommended to wear the necessary personal
protective equipment, such as wearing ear protection to reduce the risk of
hearing loss.
1.2 Equipment usage rules
（1） At the discharge end of the machine should ensure that sufficient space-space
ratio should be at least the length of the longest length of the workpiece large
500mm.
（2） User-equipped blade, cutter and cutter machine sizes must comply with the
requirements of the original configuration, the user must be selected in line
