Form 37182 Rev 201019
Page 2 of 12
Getting Started
Insert/Replace the Batteries
The AirLite with Timer is powered by three standard AA alkaline batteries located in a compartment on the bottom of the pump
(Figure 1)
. To insert new or replace existing batteries:
1. Use a slotted screwdriver to loosen the screw on the bottom of the case
(Figure 1)
.
2. Open and remove the compartment door.
3. If replacing existing batteries, remove them. Insert new batteries.
Note the polarity of the batteries.
See right
.
4. With the new batteries in place, insert the hinge
(Figure 1)
on the compartment door under the lip of the case, close the door, and
tighten the screw until secure.
Notes and Cautions
• Do not operate AirLite with Timer in hazardous or explosive locations. AirLite with Timer is designed for applications that do not require intrinsic
safety.
• Failure to follow warnings or cautions voids any warranty.
•
For maximum run time,
insert new batteries in pump before each sampling period. If using rechargeable AA 1.2-volt NiMH batteries, expect
approximately half the run time stated for disposable batteries.
• To prevent corrosion of battery terminals, remove batteries when AirLite with Timer will not be used for an extended time.
• Increases in back pressure in sampling condition due to buildup on filter can decrease battery life.
Hinge
Polarity of batteries
Screw
+
+
-
-
-
+
