Sicherheitskonzepte Breuer GmbH
Broekhuysener Straße 40, 47638 Straelen, Tel.: +49 2834 943 01 00, Fax: +49 2834 943 05 62
[email protected], www.sicherheitskonzepte-breuer.com
4
When using the Primo anchor device, the necessary clearance height below the user must be checked and guaranteed in advance. In
addition, care must be taken to minimise free fall in the event of a fall. The necessary clearance height depends on the fall-arrest system
components used (safety harness and lanyard), its maximum extension and the displacement of the anchor point, which corresponds to
the prop height. The measurement is also determined based on the extension of the energy absorber used, as well as the displacement
of the safety harness on the body (check PPE instruction manual), the height of the user and an additional one metre of safety
clearance.
The permitted strain caused by building edges and the maximum usage length when using a restraint system must also be observed.
Cleaning:
Metal components must be cleaned by wiping with a cloth after use. Other cleaning methods (chemical cleaning, etc.) are not permitted.
Repairs and inspections:
Repairs to the anchor device may only be performed by the manufacturer or an expert supplier.
The Primo anchor device must be inspected as required, however at least 1x annually, by the manufacturer or an authorised expert trained
by the manufacturer, in full compliance with the manufacturer’s instructions. In any case, the product label must be checked, and the
findings of the inspection must be entered in the enclosed test log.
This is essential because the efficacy and durability of the equipment and thus the safety of the user depends on it.
In the event of resale to other countries, please ensure that this instruction manual is available to the user in the language of the respective
country.