2
Connect the rear panel to the headboards
Fit capping screws to alternate base holes
For newborn babies up to 6 months that cannot sit up attach
the base using the upper bassinet base holes and connnect
the capping screws to lower cot base holes.
For babies over 6 months or babies that can sit up attach
the base using the lower cot base holes and connnect the
capping screws to the upper bassinet base holes.
1
Connect 1 x
fi
xed panel to 1 x headboard using 2 x panel connector screws and 2 x metal cross dowels.
Insert the metal cross dowel into top hole of the top rail of the rear panel Insert the connector bolt through the
headboard and into the cross dowel and tighten but leaving 2 mm gap between the rear panel and headboard,
repeat for the bottom hole.
Repeat the process for the other headboard, the cot can then stand on its own
Note: See detail picture below the metal cross dowel must align for the connector bolt to insert into the thread, it
can be adjusted using a screwdriver.
3
Bassinet base
holes
Cot base
holes
Summary of Contents for tasman Essentials Palermo
Page 1: ......
