SJ SJ-L869, User Manual

Page: 35 / 43

35
2- Radar Speed Camera Detector - System Function Setting
1. System Function Setting
▲ Hold the 【SET】 key on the interface of SJ-L869 for 3 seconds until system function
setting is available. After enterting system function setting, everytime you press 【SET】
key for 1 second, you can select setting in turn,and hold the 【SET】 key for 3 seconds
to save setting, or wait for backing to original screen automatically.
1.1 The radar mute setting could be set from 0 KM to 150 KM, you can adjust per 10 KM. The
default is 50 KM. When the speed is low than 30 KM, the device would be mute automatically
and only twinkles even if detected electric wave radar system.The system could block automatic
door and the other noise interference in the city.
1.2 The exceed the speed limit setting could be set from 0 KM to 150 KM, you can adjust per
10 KM. The default is 150 KM.If you set 100 KM for speed limit, but you exceed over 100 KM,
the system would make noise for the warning of exceed the speed until slow down to the setting.
The function could be base station to position to warn the speed limit, and upload the data
by base station to share woth other users.
1.3 The fine tuning could be set from 0 KM to 20KM, The default is 50 KM. When the GPS speed
is not identical with the car speed, you can adjust the GPS speed to be identical with the
car speed, after observing average deviation.
1.4 You can adjust alarm voice setting to sounds and noise mode→sounds mode→continuous noise
mode, three kinds of alarm voice modes are as below:
▲ Sounds and noise mode: in this mode, when the car approaching the warning point of the
speed camera system, except announcing of the kind of speed camera, speed limit and countdown
of distance, when the car speed exceed the limit of camera, the system would make 【Ding Dong
】 warning noise automatically. When the car speed is lower than the speed limit, the system
would stop making 【Ding Dong】 warning noise automatically, and keep countdown.