46
Adjusting idling speed:
1.
If the engine tends to stop frequently in idle mode, turn the adjusting screw clockwise.
2.
If the cutting head still rotates after releasing the throttle trigger, turn the adjusting screw
counterclockwise.
NOTE: Warm up the engine before adjusting the idling speed.
(1): Idling speed adjusting screw (cross screw)
Cutter application chart:
Use only accessories recommended by the manufacturer according to the nature of the surface you are going
to cut.
Metal blade usage:
1.
Check that the blade screw is tight and make sure it is not damaged.
2.
Make sure that the blade and holder are fastened according to the manual and that the blade rotates
freely without excessive noise.
Rotating parts that are not attached correctly can cause serious injury.
Make sure the blade is not bent, cracked or otherwise damaged. If the
knife is not in one hundred percent condition, remove it and replace it
with a new one. When using the strap, place the brush cutter on your
right side. Adjust the length of the strap so that the cutting head is
parallel to the ground.
WARNING: Be sure to use the shoulder strap and the cutting
head guard. If this is not the case, you risk serious injury if you
trip or lose your balance. Use only original cutting blades and
heads.
