Sistemes Electronics Progres Agronic Smart, User Manual

Page: 17 / 32

Manual - Agrónic Smart ·
17
6.7. CONFIGURING THE INSTALLER
Select the “Installer access” button to enter the installer configuration section.
The following may be established:
• Summer/winter time: You can set the controller
to automatically change the time during daylight
savings in the spring and autumn. Automatically
set by default.
• Output type: 2-wire, 2-inverted-wire (by default)
and 3-wire latches.
• Activation level: 13V (by default), 19V, 5V
• Application PIN code: This refers to the password
needed to connect using Bluetooth. Initially, the
PIN code is set and provided by Progrés. But,
through the installer configuration, you can set a
different number. It must always have 6 digits.
• Activation of Plus version: By entering the
applicable code (this information is provided by
Progrés under contract), you can activate the Plus
version, which adds extra functionalities to the
controller:
‒ Alternating sequence: Each time a program
starts, it will do so in a different sector, in
accordance with the sequence defined in the
program.
‒ Use of fertilizer
• Updating controller firmware: If there is a firmware
update available for the controller, the “update”
button will appear. If there is an action in progress
or programs irrigating, the button will disappear
until they are complete so that the update does not
affect the programming.
The update process can take several minutes.
It is important not to close the application or
disconnect the controller.