31
P01 Det.factor 4, type: 10
Reference for calculation : + 0.80 mm/d
In the irrigation program, next to the manual fac-
tor, pressing the “mode” button will ask for the modifi-
cation factor. In an evapotranspiration sensor the
“crop constant” is used; in other types of sensors, the
value can be left at 1.00.
Etc = Eto * Kc
Etc = Evapotranspiration of crop
Eto = Evapotranspiration
Kc = Crop constant
Example: A farm cultivating three different crops
can use three irrigation programs; one per crop. Each
program is conditioned by the same evapotranspira-
tion sensor, whose value is periodically sent via SMS
message to the owner when it detects a variation in
the institutional meteorological season. To sum up, a
single SMS can optimize irrigation needs.
6.8. COMMUNICATION PARAMETERS
[ check the Communication Options pamphlet ]
6.9. VARIOUS PARAMETERS
In order to adjust the sonorous level of the key-
board “bip”, 1 has to be entered for a low level and 9
for the highest one. It remains disabled at 0.
Keyboard sonorous level : 2
The Agrónic 4000 allows access codes in order to
limit the functions and/or parameters use. The codes
are formed by four digits and can be modified at this
section. To do so, the correct code has to be entered
modifying it afterwards if necessary. When it shows
the value “
- - - -
” it means there is a code assigned
but there is no code with “
0000
”.
In order to cancel the question, assign code 0 at
functions or parameters.
Functions access code : - - - -
Parameters access code : 0000
In order to guarantee the correct use of the SMS
messages from a mobile phone it is necessary to en-
ter here the access code which will contain a message
later on. Further details at section “Message sending
from a GSM telephone” in the Communication Op-
tions pamphlet.
SMS messages access code : 1234
After entering a number in the
PIN code
, the theft
protection is activated. If Agrónic is above 10' without
power supply, it will require the PIN code to be fed
again. If the wrong activation code is entered three
times, the Agrónic gets blocked, asking for the deacti-
vation code (PUK). You will need to contact the PRO-
GRÉS in order to obtain the deactivation code. If you
do not want to use this protection, leave the PIN code
to 0.
If you want to change the PIN code, you must first
enter the current PIN, otherwise you will not be able to
change it.
Code PIN : 1234
If due to practical needs some programs or sec-
tors want to be copied, it can be done from this sec-
tion.
Copy programs (Y/N) : Y.
Copy program 00 from 00 to 00
Copy sectors (Y/N) : Y.
Copy sector 00 from 00 to 00
