Siruba HSM-2517, Instructions Manual

Page: 10 / 24

-9-
C
H
Reverse stitch lever
Presser foot lever
Hand wheel
Stitch lendth dial
Power/light switch
Stitch selector
Stitch width/needle
position dial
Stitch indicator
2
4
3
I
J
F
J
I
H
G
D
E
hand wheel toward you.
Take-up lever
Tension dial
highest position by turning the
Raise the take-up lever to its
Thread tension - 3
Stitch length - 2 - 3
Stitch indicator - A
Straight stitch most frequently used for every aspect of sewing.Learn the correct method of your
machine following the steps below.
Stitch Length
Stitch Width
Stitch Selector
STRAIGHT STITCHES
1
F
B A D C
G
E
B
A
1.SETTINGS
2.Pull both threads under the
3.Place the fabric under the
4.Turn the hand wheel toward
presser foot and lower the
presser foot lever.
you until the needle enters the
fabric.
presser foot toward the back
of the machine.
Needle position for straight stitching
5 L
4
3
1
1
2
2
1
4
3
M
3
R
2
Straight stitch at right needle position with needle
Straight stitch at middle needle position with needle
Straight stitch at left needle position with needle position
position control set at M.
position control at R.
3
control at L.
2
1
5 6
machine by releasing the foot control.
presser foot, leaving 4 inches (10cm) thread tail.
d. Pull both threads under and to the back of the
cut off excess threads.
c. Use the thread cutter above the presser foot to
b. Raise the presser foot by pushing the lever up.
6. a. Turn the hand wheel to raise the needle.
c. When you reach the end of the fabric, stop the
b. Guide the fabric gently with your hand.
5. a. Start to sew stepping on the foot control.
A
2-3
3