Siruba DT828L, Manual

Page: 11 / 46

加油方法
在加油未完成前，請勿插上電源。
當勿按到啟動開關時，縫紉機動作會導致人
員受傷。
使用潤滑油和黃油時，務必戴好保護眼睛和
保護手套等，以防潤滑油落入眼中或沾在皮
膚上，會引起發炎。
將油放在孩童拿不到的地方。
潤滑油或黃油不能飲用，否則會引起嘔吐和
腹瀉。
在剪去油壺的油嘴口時，請一定要拿住油壺
的根部。
如果拿住油嘴口，剪刀容易傷到手，成為受
傷的原因。
①必須經常潤滑縫紉機，第一次使用縫紉機
或長時間未使用縫紉機時，要補充機油。
1. 握住油壺（ 1 ）油嘴基座，並用剪刀沿油嘴
的直線段（
A
）剪下一半左右。
2.
擰鬆並移除油嘴，然後移除油封（
2
）。
3. 擰緊油嘴。
②給油盒加油
1.
油壺（
1
）的油嘴插⼊加油橡皮塞（
5
）孔內，
注⼊潤滑油，直到潤滑油的液位到達油標
（
3 ）的頂部基線（ 2 ）處。
*
當潤滑油的液位下降到基準線（
4
）以下
時，請務必補充潤滑油。
Lubrication
Do not connect the power cord until lubrication has been
completed, otherwise the machine may operate if the treadle
is depressed by mistake, which could result in injury.
Be sure to wear protective goggles and gloves when handing
the lubricating oil and grease, so that they do not get into
your eyes or onto your skin, otherwise inflammation can resul.
Keep the oil out of the reach of children.
Do not drink the oil or eat the grease under any
circumstances, as they can cause vomiting and diarrheat.
When cutting the nozzle of the oil tank, hold the base of the
nozzle securely.
If your hold the end of the nozzle, injury from the scissors
may result.
①
The sewing machine should always be lubricated and the
oil supply replenished before it is used for the first time,and
also after long periods of non-use.
1.Hold the base of the nozzle of the accessory oil tank (1)
and use scissors to cut about half-way along the straight
section (A) of the nozzle.
2.Lossen and remove the nozzle, and then remove the seal
(2).
3.Tighten the nozzle.
② Oil box refueling
1.Insert the nozzle hole filling rubber oil. use the accessory oil
tank (1) to pour in lubricating oil until the oil level reaches
the top reference line (2) of the oil gauge window (3).
*If the lubricating oil level drops below the bottom
reference line (4), be sure to add more oil.
P5
① ②