Sirona ORTHOPHOS XG 3 DS, Service Manual

Page: 67 / 578

båÖäáëÜ
59 38 399 D3352
D3352.076.01.13.02
07.2008
2 – 9
Tab 2 2.5 List of error messages
2.5
2.5
List of error messages
HINWEIS
i
In the following table, the error codes are sorted by the location or function unit
where the error has occurred. For enhanced clarity, the corresponding ID in
the error code is printed in bold type.
Location 06: Tube assembly / Board
Error code Description Actions required see page
E6 06 01 General error during module initializa-
tion
z
Please contact the Sirona Customer Service
Center (CSC) to find out whether a bugfix by
means of a software update is possible and per-
form such an update if necessary.
1-22
z
If the error occurs frequently,
replace the X-ray tube assembly
6-38
E6 06 02 Invalid system data or uninitialized
module storage data
z
Perform service routines S005.2
5-29
z
Please contact the Sirona Customer Service
Center (CSC) to find out whether a bugfix by
means of a software update is possible and per-
form such an update if necessary.
1-22
E6 06 03 Invalid commanding of control data,
CAN bus error
Note:
This error may also occur in connec-
tion with other causal error messages!
Please also observe the causal error
message! It appears only after you
acknowledge the first error message.
z
Checking the CAN bus
3-6
z
Please contact the Sirona Customer Service
Center (CSC) to find out whether a bugfix by
means of a software update is possible and per-
form such an update if necessary.
1-22
E6 06 04
Data transfer error or dialog error to
module (master side)
z
Checking the CAN bus
3-6
z
Please contact the Sirona Customer Service
Center (CSC) to find out whether a bugfix by
means of a software update is possible and per-
form such an update if necessary.
1-22
E6 06 05 Data transfer error or dialog error to
bootloader of module
Note:
Occurs only in connection with soft-
ware update
z
Repeat software update
1-22
z
Checking the CAN bus
3-6
z
If the error occurs repeatedly or the module is
no longer addressable, replace
the tube assembly
6-38
E6 06 06 Module failed in TTP*
(detected on master side)
Note:
This error may also occur in connec-
tion with other causal error messages.
Please also observe the causal error
message! It appears only after you
acknowledge the first error message.
z
Checking the CAN bus
3-6
z
Please contact the Sirona Customer Service
Center (CSC) to find out whether a bugfix by
means of a software update is possible and per-
form such an update if necessary.
1-22
z
If the error occurs repeatedly or the module is
no longer addressable, replace
the tube assembly
6-38