62 07 687 D3530
8
D3530
.
201.01.06
.
02 07.2011
2 Safety information
Sirona Dental Systems GmbH
2.1 Information on the unit
Operating Instructions LEDview / LEDview S
2
Safety information
Safety information
2.1
Information on the unit
Information on the unit
One of the two adjacent symbols can be found on the unit rating plate:
● Observe accompanying documents
The accompanying documents are attached to the unit.
2.2
Care and cleaning agents
Care and cleaning agents
Unsuitable care and cleaning agents may corrode the surface of the unit.
Therefore, use only care and cleaning agents which have been approved
by Sirona. For more information, please refer to "Care and cleaning
instructions for the practice team".
2.3
Trouble-free operation
Trouble-free operation
Generally valid
Use of this system is permissible only if it works properly without
malfunctions. If trouble-free operation cannot be ensured, the unit must
be taken out of service, checked by authorized technicians for
malfunctions and, if necessary, repaired.
2.4
Blinding
Blinding
2.5
Composite mode
Composite mode
WARNING
Due to the extreme brightness of the LED technology employed,
directing the light beam into the patient's or user's eyes should be
avoided! Briefly looking into the light beam is harmless.
WARNING
Patients with the very rare (approx. 1: 250,000) condition Xeroderma
pigmentosum must not be treated with the light on full power. You must
consult the dermatologist treating the patient concerned in each case.
IMPORTANT
To prevent premature curing when composite fillings are used, always
operate the light in composite mode under these circumstances. The
brightness is then limited to approx. 8,000 lux. Despite the reduction in
illuminance, modern high-sensitivity composite materials in particular
can cure prematurely as a result of other light sources, e.g. cap lamps,
ceiling lamps, daylight, etc. The application procedure must, therefore,
be checked on an individual basis.