63 98 536 D 3439
D 3439
.
201.06.10
.
02 10.2017
45
Dentsply Sirona
6 Operation
Operating Instructions CEREC MC XL Premium Package
6.4 Entering the bar code
båÖäáëÜ
6.3.5
Information on the seal of approval
Proper selection and processing of the material are decisive for the long-
term clinical success of the restoration, especially in the case of zirconia.
However, different types of zirconia require individually matched machine
parameters. This is the reason why you can and must select different
types of zirconia in the software. These machine parameters are
coordinated between material partners in complex development
processes. In addition to the desired fit and surface quality, they also
guarantee a maximum degree of material and equipment safety.
Consistently high quality of the grinding or milling result and the fit can be
guaranteed and damage to the processing machines can be excluded
only if certified materials are used.
Fragment: Everything excluding FONA
6.4
Entering the bar code
Barcode Reader active
If you have activated the
"Barcode Reader"
option in the unit
configuration dialog (e.g. for CEREC Zirconia), you must use the barcode
reader to read the two barcodes. To do this, hold the bar code reader
tilted to a slight angle and move it over both of the bar codes on the block
continuously and evenly.
If the read attempt fails, you can also manually enter the substitute code
(8-digit character string, e.g. *1234XYZ) on the touch display.
Barcode Reader not active
If the option
"Barcode Reader"
has been deactivated in the system
configuration dialog, you will always be prompted to enter the substitute
code (8-digit character string, e.g. *1234XYZ) on the PC or the touch
display manually.
NOTICE
Block without seal of approval
If a block is found without a seal of approval during the machining
process (milling or grinding), the following message appears:
"No quality label was recognized on the block. The grinding and milling
processes as well as the instruments are specially verified for certified
materials. Certified materials can be identified by the engraved "inLab"
lettering on the block. The use of zirconium oxide materials without
quality label can lead to inferior results as well as increased wear on the
device and instruments.
Do you still wish to start the manufacturing process?"
Summary of Contents for CEREC MC XL Premium Package
Page 77: ......
