5
5. Setting the end positions
You need to define the upper and lower end positions, when reaching these, the
drive switches off automatically. To do this, the drive system must be fully inserted.
You can choose whether to set the lower or upper end position first.
The time between each button combination should not exceed 6 seconds.
Otherwise, the setting status is aborted.
With some roller blind fabrics, enormous temperature fluctuations cause the fabric
length to change. Depending on the fabric and overall length, in extreme cases, there
can be a shortening in cold weathers and a lengthening at high temperatures, which
can even be in the centimetre range. Especially for cassette systems it is absolutely
necessary not to parameterize the upper end position up to the stop but to leave at
least 1 cm clearance!
Setting the end position: The setting of the upper end position is shown in the following.
Thus, the upper end position is set. The setting of the lower end position is analogous by
replacing the up button with the down button. If both end positions are set, the drive will
automatically stop at the respective end positions during operations.
Changing the end position (option): The following shows how to change the upper end position.
Thus, the upper end position is changed. You can also change the lower end position in the
same way.
1. Press the up
button and let the
drive move upwards.
3. Press and hold the up and stop
buttons simultaneously until the
motor reacts with two up/down
movements. Release the buttons
again.
1. Press and hold the up
and
stop
buttons
simultaneously until the
drive reacts with a singe
up/down
movement.
Release
the
buttons
again.
2. Then move the
drive to the new
desired end position
using the up and
down buttons.
3. Press and hold the up and
stop buttons simultaneously
again until the drive reacts
with
two
up/down
movements.
Release
the
buttons.
2. Press the stop
button when the
motor has reached
the desired upper
end position.
