8
Battery Installation
IMPORTANT:
Your wireless sensor comes with
a CR2430 internal battery which will need to be
installed prior to pairing the wireless sensor with the
main device.
Please be sure to follow the steps below:
•
Attach sensor tail (
if applicable to sensor type
).
•
Remove the four screws on the back of the
wireless module and remove sensor back.
•
Insert the CR2430 battery into the battery
holder. Be sure that the
positive (+)
side of
the battery is facing up.
•
Replace the back of the sensor and tighten
the four Phillips screws. Use care when closing
up the wireless module. Make sure to tighten
the screws and that all seals and O-rings are
secure and in place.
NOTE:
Do not over-tighten.
