Technical Information
TI02ENG124R8
100 HUNTER PLACE, YOUNGSVILLE, NC 27596 USA
Ph: (919) 554-2244, (800) 356-7311 • Fax: (919) 554-2266, (800) 899-8181 • Web:
www.sirchie.com • Email: [email protected]
FIG 1: Battery Installation
Safety Precautions
CAUTION
: Due to the intensity of the light, do not look directly into the beam.
Reversing the battery may permanently damage the flashlight and the battery pack.
Electrical Info
Battery: 6volt, 3.5 amp-Hr nickel metal hydride (Ni-Mh) battery pack
Switch: Recessed, push-on – push-off soft touch button
Illuminator: High output LED
Charger: Input :Universal voltage 100-240VAC, 50/60Hz, Output: 12VDC
Charge Rate: 220 – 400 mA (typical)
Charge Time: Completely discharged battery : 12-16 hrs
Light Operation
The ON-OFF button is located at the base of the head cap. Press for ON. Press again for OFF.
Beam Adjustment
The head of the flashlight can be rotated slightly left or right in order to achieve the best
beam pattern for your use.
Charger Operation
The Charger Cradle may be used free-standing or permanently mounted to a surface, such
as a desk, wall or in a vehicle. Recessed mounting holes inside the cradle accept up to #8
mounting screws, which should be a minimum of 1 inch (25mm) long.
Insert the Charger Plug head into its port at the front of the Cradle. Align the rim of the light
with the back side of the Flange and snap the BLUEMAXX into the Charging Cradle. The
Retainer Tabs will hold the light securely. The Contact Rings on the flashlight body will now
be touching the metallic Charging Contacts in the bottom of the Cradle, allowing the battery
to charge. To remove the light from the Charging Cradle, lift it straight up and out.
+
