4
Connect the camera
It is necessary to connect the camera to power, network, audio and alarms before you install
the camera. The connectors are located on the bottom of the camera body.
In This Chapter
4.1
Prepare the camera for installation
To prepare the dome camera for installation
1
Unpack the dome package and take out the dome body.
2
Rotate to remove the protective cover.
3
Remove the PE cloth sheet and take off the lens cap.
4
Carefully screw the dome cover onto the camera body.
5
Make a note of the IP address, which is on the label attached to the metal plate on the
bottom of the camera.
It is not be visible when the dome is assembled. For more information on accessing the
camera's internal settings, see Establish a network connection.
4.2
Connector and switch definition
It is necessary that the dome ID and communication protocol remain in the default modes
when connecting the MSD620 to other devices. The switches used for configuring these
settings are located on the bottom of the dome camera. These settings are preset to operate
the camera with the IP hardware. Changing the settings may make the camera inoperative
using the IP connection.
See the figure and table below for switch location and definitions.
12