12
OPERATING INSTRUCTIONS
A
B
C
1
2
13, 15 & 19mm
25mm
32mm
Choose the correct hose adaptor size to match your hose (diagram below).
13, 15 & 19mm HOSE
Remove the topmost nipple from the hose adaptor (1).
Screw a 1” bsp female tap adaptor onto the hose adaptor.
Fit an equivalent hose connector to the hose.
Connect the hose connector to the tap adaptor.
25mm HOSE
Push a hose of 25mm onto the hose adaptor without cutting anything.
Tighten the hose with a pipe clip or similar, where necessary.
32mm HOSE
Remove the top two nipples from the hose adaptor (2).
Push a hose of 32mm onto the hose adaptor.
Tighten the hose with a pipe clip or similar, where necessary.
ATTACHING THE HOSE
Note:
Pipe clips, hose connectors & tap adaptors are not supplied.
13
OPERATING INSTRUCTIONS….cont
Screw the hose adaptor onto the elbow, then screw it into the side of the water
pump.
Push your hose onto the hose adaptor (see page 12).
Secure using a relevant pipe clip or similar (pipe clip not supplied).
Lower the pump into the water, use rope or similar around the handle to lower it
into position where required.
Note:
Do not use the mains lead or float switch to lower beyond reach.
Warning:
The water pump should be fitted with an RCD (residual current
device), or similar, to ensure the power is cut should any problems occur.
When installing, please ensure your SIP submersible pump is disconnected from the
electrical supply to prevent possible injury to people and / or damage due to un-
wanted start up.
You may need to shorten the length of the float switch
in order to control the depth of which it cuts power to
the pump (see right diagram).
Once the water pump is in position, connect to a pow-
er supply and switch on. After a few moments, the
pump should start to pump the water; if the water is
too low it will not pump until the water has risen high
enough to engage the float switch.
INSTALLING THE PUMP