SIP SILVERCUT DISC 1000 C, Instruction For Work

Page: 107 / 138

Instruction for work
14
2. Preparing
2.1 Special safety instructions
– When performing check up,
maintenance repair and mount works
always switch off the P.T.O.shaft.
Switch off the engine and pull out the
ignition key. Secure tractor against
movements.
–
Maximum P.T.O. shaft rotation is
1000 rpm.
– Devices like string, hydraulic tubes,
electrical installations must be placed
so that any unintentional pull or touch
with tyres is impossible. Risk of
accident!
– Nobody is allowed to stay between the
tractor and the machine when lifting
or lowering the swather with tractor
hydraulics.
– Make sure nobody is in the danger
area of the swather before switching
on the P.T.O. shaft. High injury risk!
– Pay attention to use protections
according to regulations when
working or driving on the road. Mount
the light equipment and check its
functioning.
– Never leave the driver seat during
working.
Before connecting or disconnecting the mower to the
three point hydraulik hitch bars set the control levers
into the position that excludes an unintentional lifting
or lowering of the three point hitch!
Connecting and disconnecting the mower requires
special attention!
In the area of three point hydraulic hitch bars there is
danger of injuries being caused by squeezing and of
bruises!
Mowing is done with third category three-point
hydraulic lift.
2.2 Attaching to the tractor
The mower is designed to already meet operational
settings prior to attachment (operating mount height
and ridge inclination of 2 degrees in the direction of
travel are already set).
Serial installation of third category three-point
hydraulic lift.
– Pay attention that nobody is between
the tractor and the machine when
connecting the machine to the tractor.
– Fix the lower bars in order to prevent
the side oscillation of the machine in
transversal drive and not to endanger
the safe drive.
2
3
4
3
1
2
4