3
Guide to Installation, Programming & Operating
WARNING
– To guard against injury, basic safety should be observed including the following: Read all instructions,
specifications, cautions, and warnings before installing and using SIP NEO
3
. Learn the specific details regarding installation and
use. Failure to follow them could cause serious injuries and possible property damage.
DANGER
– To avoid possible electrical shock, unplug dispenser prior to installation of SIP NEO
3
.
All Power cords must be three-pin plugs to be grounded. Do not use two-pin plugs.
Power supply cord must be plugged into electrical wall outlet. DO NOT plug into extension cord.
Do not stand on wet floor when installing and servicing the water dispenser.
Install check valve on silicone tubing prior to the diffuser to avoid water from reservoir flowing backward causing damage to
ozone generating device.
SAFETY PRECAUTIONS
!
INSTALLATION STEPS
SIP NEO
3
is designed to use in all brands of bottle and bottleless water coolers (dispensers). The system can be installed on the
back of the dispenser or on the wall at the back of dispenser so as to display the indicator light and screen for proper consum-
er use.
Install to back of the dispenser using zip ties to secure ozone generating device and control system device onto the back of
cooler’s condenser, or the grids, or on the wall at the back of dispenser. Control Device System should be installed to the right
of the Ozone Generating Device.
HOW TO INSTALL OZONE GENERATING DEVICE AND CONTROL SYSTEM DEVICE
WHERE TO PLUG IN POWER CORDS (FIG 1)
NEO
3
COMPONENT CHART
Plug the main power supply cord into the “POWER” receptacle (bottom of the control device system, left side). Plug the short
power outlet cord (converter cord) into “UNIT” receptacle (bottom of the control device system, right side). Plug the water
dispenser power cord into the opposite end of the short power outlet cord (converter cord).
Important:
All float mechanisms are not identical and the
optimal location of the down rod may vary depending on
your particular float system.
SEL
06/29/17 FR
12:15
Display Screen
Diffuser
12 Volt Connector Cable
Power Cord to Dispenser
Power Supply Cord
Filter Disc Port
Filter Hatch
Check Valve
Silicone Tube
Mounting Tab
Indicator Light
Fuse
A
B
Power
Unit
Air Filter Disc
Cable Lock
(Fig 1)
HOW TO SECURE THE CONNECTOR:
1. Locate the Cable Lock Cap on the side of the unit.
2. Turn the Cap counterclockwise to loosen.
3. Firmly insert the 12 Volt Connector Cable into the
Connector Cable terminal.
4. Turn the Cap clockwise to tighten, being careful not to
overtighten.
