22
MAINTENANCE
CHANGING THE BLADE
A
B
Turn the circular saw to the `OFF` position.
Isolate the saw from the mains spply.
Raise the head upwards.
Remove hex. bolt (A).
Slide arm (B) out of the way.
Caution:
The blade bolt is a left handed thread, meaning to undo it you
must turn the bolt clockwise, failing to do this will strip the threads on the
blade shaft and will void your warranty.
Slide both movable guards (C) out of the
way.
Remove the blade bolt (D) by turning it
clockwise to undo it, a soft mallet may be
required just to loosen the bolt as it will be
tight, but do not hit it too hard.
Once the blade bolt is out, remove the
blade flange then the blade.
C
C
D
15
ASSEMBLY INSTRUCTIONS….cont
Handle trigger
FITTING THE HANDLE LEVER
Remove the transit bung from the head.
Screw the handle lever into the head and tighten
the nut, so the handle lever can`t move.
Handle
Lever
Nut
Screw one half of the plastic handle onto the head
lever using the handle screw, push the micro switch
into the handle making sure it pushes into both pins,
then fit the handle trigger onto the handle.
Handle lever
Handle
screws
Micro switch
Handle
trigger
Handle
Items needed
Locate the micro switch wire on the back of the
electrical box and connect the two wires onto
the micro switch; one wire to the C (common)
connection and the other to the NO (normally
open) connection.
Common
Normally open
Micro switch
