14
Note:
If any items are missing or damaged,
DO NOT
use the machine
and contact your distributor immediately.
Danger / Caution:
This is a minimum of a 2 man operation to remove this circular
saw from its packaging as its extremely heavy, failing to do this can have serious
consequences and could lead to personal injury and/or the possibility of damage.
Place the stand into the location where the circular saw is to be used.
Bolt the stand to the floor (bolts not supplied).
Remove the circular saw from its packaging.
FITTING THE CIRCULAR SAW TO THE STAND
Using proper lifting equipment and lifting
straps, raise the circular saw up so that it is
slightly higher than the stand.
Danger / Caution:
Always using proper lifting equipment to move the cir-
cular saw onto the stand,
NEVER
attempt to lift the circular saw without
lifting equipment as this is extremely dangerous.
Slowly move the saw over stand then slowly lower the saw onto the stand, ensur-
ing the four holes match up on the stand and saw.
Secure the circular saw to the stand using the four hex bolts supplied.
Remove the straps from the circular saw.
ASSEMBLY INSTRUCTIONS
23
MAINTENANCE….cont
CHANGING THE GEAR BOX OIL
Turn the machine to the `OFF` position.
Raise the head upwards.
Place a container on the base of the cir-
cular saw and inline with the oil drain bolt.
Remove the oil drain bolt to let the oil flow
into the container, you may need to pull
the head slightly forward to get rid of the
remaining oil.
Once all the oil is out refit the oil drain
bolt.
Remove the oil fill bolt.
Pour oil into the oil fill hole with EP90 gear
oil until it reaches around the red dot on
the oil sight glass.
Refit the oil drain bolt.
Note:
Contact your local authority on how / where to dispose of the waste
oil.
Oil drain
bolt
Oil sight
glass
Oil fill bolt
Place the new blade over the blade
shaft lip.
Fit the blade flange over the blade,
turn the blade until the two pins on the
blade flange slot into the two blade
holes.
Now turn the blade again until the two
pins on the blade flange slot into the
two blade shaft holes.
Refit the blade bolt by turning it anti-
clockwise to tighten it up.
Slide both guards (C) back down and
refit the arm (B) with bolt (A).
Blade
Blade
shaft
Blade
flange
