2
SOUND AND VIBRATION READINGS
*Sound Pressure
*Sound Power
*Vibration
Catalog No.
dBA
dBA
m/s
2
SZER4003LV
89.0
100.6
2.7
SZER4006LV
89.0
100.6
2.7
*per PN8NTC1
*per PN8NTC1
*per ISO 8662
DECLARATION OF CONFORMITY
We, Sioux Tools Inc., 250 Snap-on Drive, P.O. Box 1596, Murphy, NC, 28906, USA, declare under our sole responsibility that the products
SZER4003LV & SZER4006LV
to which this declaration relates are in conformity with the following standard or standards or other normative document or documents:
EN 792, EN 292 Parts 1&2, ISO 8662, Pneurop PN8NTC1
following the provisions of
89/392/EEC as amended by 91/368/EEC & 93/44/EC Directives.
December 1, 2003
Murphy, North Carolina,
USA
Date and place of issues
Gerald E. Seebeck
President
Sioux Tools Inc.
Name and position of issuer
Signature of issuer
When disposing of a tool, do it in a way that does not harm personnel or the environment.
Tools left connected to the air supply while making adjustments, changing accessories, or doing any
maintenance or service on tool can start unexpectedly.
Always remove tool from air supply and activate trigger to bleed air line before making any
adjustments, changing accessories, or doing any maintenance or service on tool.
Tools starting unexpectedly can cause injury.
Routers may coast for a short time after the trigger is released.
Be sure tool has come to a complete stop before setting it aside.
Routers that do not come to a complete stop before setting aside can cause injury.
AIR SUPPLY
The efficiency of the tool is dependent on the proper supply of clean dry air at 90 psig (6.2 bar). The use of a line filter, pressure
regulator, and lubricator will insure maximum output and life of tools. Before connecting tool, blow out the air line to remove water
and dirt which may have accumulated.
HOSE AND HOSE CONNECTIONS
Supply hose should be not less than 3/8" (10mm) I.D. Extension hoses should be at least 1/2" (13mm) I.D. Use couplings and
fittings with at least 3/8" (10mm) I.D.
LUBRICATION
Use SIOUX No. 288 air motor oil. An airline lubricator, set to deliver 2 to 3 drops per minute, is recommended. If a lubricator is not
used, add .08 oz. (2.4 cc, 24 to 30 drops) of oil into the air inlet every 2 to 3 hours.
GENERAL OPERATION
•
The tool may be equipped with a lock-out type lever in order to prevent accidental startup.
•
For best results, the direction of the tool travel is generally from left to right.
•
It is recommended that movement be counterclockwise on outside curves and clockwise on inside curves. The tool spindle
rotates clockwise.
CHANGING CUTTING BITS
1.
Disconnect tool from air line.
2.
Remove nose piece assembly.
3.
Hold spindle stationary with a wrench. Loosen collet nut with wrench.
4.
Insert bit into collet to desired depth. Tighten collet securely. Replace nose peice assembly.
ADJUSTMENTS
1.
Nose height may be adjusted to expose desired length of cutter edge by loosening the lock ring and rotating the nose.
