SinoCon KonNaD C2000-A1-SDD1010-AB3, User Manual

Page: 4 / 34

1. Getting Started
1.1. Preparation Before Use
You will need the following hardware and software to use the C2000-A1-SDD1010-AB3.
C2000-A1-SDD1010-AB3 module
A power source that provides 9 to 27 VDC, and power wires
A PC running a Windows 7 or later versions, and an Ethernet cable
KonNaD Settings Utility software
1.2. Wiring
Refer to
Port Description
for the recommended wires.
After the device is powered on, the PWR is steady red, the RUN is flashing, which indicates the device is powered
normally.
Plug the network cable into the Ethernet port of the device, and the other end of the network cable is plugged
into the computer or router. The SPD is steady on, the LINK is flashing, which indicates the device has been
properly connected to the network
C2000-A1-SDD1010-AB3 User Manual
4 / 34
SinoCon Co., Ltd. www.sinoconsys.com