DIAMOND AUDIO MICRO 4V2
1.
Remove the fuse from the SinisterSound power and ground cable.
2.
Connect the SinisterSound power and ground cable to the amplifier and route towards
the battery through the cable channel under the tank.
3.
Connect the RCA harness to the amplifier Input port and the RCA’s to the output ports of
the head unit. Connect the remote turn on wire to the head unit wiring harness.
4.
Connect the speaker pod wires to the CH1 and CH2 output harness and connect the
harness to the amplifier.
5.
Change the amplifier settings as shown in the table below.
6.
Connect the power and ground cable to the battery
7.
Insert the fuse on the power and ground cable.
8.
Continue to the Testing and Tuning section.
Diamond Audio 4v2 Amplifier Settings
Diamond Audio 4v2 Input Side
1. Set X-Over to HP
2. Set Freq to around 100Hz (a couple of clicks clockwise from horizontal)
3. Set Turn-On Mode to REM
4. Set Config to 2CH
1.
2.
3.
4.
P A G E
!
O F
!
1 1
1 4
R E V 0 0 1
Output
Side
Input
Side
Front
