|
Spectre 3.0 Assembly Manual
Revision 1.2
Page
| 18
Step 10: Install 2
nd
Vertical GPU Mount. (This add-on does not come included with the
case).
Pieces Involved
•
Spectre 3.0 Case
•
Fasteners – 2x 6-32 x 0.5”
•
Vertical GPU Bracket & Ribbon
Cable
•
Fasteners – 2x 6-32 Nuts
•
Vertical GPU Angle
•
Fasteners – 2x M4 x 10mm
•
Vertical GPU 2
nd
Angle
Remove the PSU Side Panel to gain access into the PSU Shroud. Install the 2nd Vertical GPU
Bracket using the 2x M4 x 10mm Fasteners, which also has the Ribbon Cable attached. Then
remove the Vertical GPU Angle if it is already installed. When installing the first and second
Vertical GPU Mounts both angle pieces are installed with the same fasteners. These fasteners
come included with the 2nd Vertical GPU Mount and are longer than the ones included with the
case. Use the 2x 6-32 x 0.5” Fasteners to go through the Vertical GPU Angle, then through the Rear
IO Panel thread, then through the Vertical GPU 2nd Angle, then 2x 6-32 Nuts to fix everything
together from the back. Be careful to select the correct position on the Rear IO Panel so that the
angle is at the correct height for your GPU.
