Singer SUPERA, Instruction Manual

Page: 97 / 188

INTRODUCTION
Intended Use
Optimal use and maintenance are described in these instructions. This product is not intended for industrial use.
Additional assistance, by region, may be found on the web at www.singer.com.
Machine Overview
3
1
5
6
10
9 8 7
4
12
11
2
13
1. Feed Teeth Lever — move from side to side to engage or
disengage the feed teeth. Positioned at the back of the free
arm.
2.
Accessory Tray / Free Arm
— provides a flat surface
when sewing and allows storage for your accessories.
Remove the accessory tray to use the free arm which
makes it easier to sew, e.g., trouser hems and sleeves.
3. Thread Knife — for trimming thread ends at the end of
sewing.
4. Threading Slots — thread paths with tension discs and
take up lever.
5. Reverse Button — Press and hold to sew in reverse, e.g.,
when securing the beginning or ending of a seam.
6. Start/Stop Button — Press to start and stop sewing
without using the foot control.
7. Presser Foot Pressure — controls the pressure the presser
foot exerts onto the fabric.
8. Thread Tension Dial — set the right tension for your
stitch, thread and fabric.
9.
Machine Operation Controls
— functions used to make
your sewing more convenient (see page 18).
10.
Display
— Current stitch and settings are displayed.
11. Hand Wheel — used to manually control the movement of
the needle and the thread take-up lever.
12. Stitch Control Panel — Choose stitch menu, select stitch
and adjust your stitch settings with these buttons. Here you
also find functions for sequencing, mirroring and
elongation (see page 19).
13. Stitch Charts — Slide forward and view all stitches
available on your machine.
Introduction – 1
English