WARNING: This shower head is designed to operate with a water pressure of 20-80 psi
(corresponding to
approx. 1.5 to 5.5 bar): If the water pressure is less than 20 psi, the built-in hydraulic generator cannot
generate enough pressure to operate the system. Pressure above 80 psi may damage the shower head.
Assembly and assembly of the shower head must be carried out by experienced people or by your trusted
plumber.
It is advisable to cover the base of the shower to avoid losing any component of the shower head.
Before starting the installation close the supply of both cold and hot water. Remove the existing shower
head, beingcareful not to unscrew the arm. Before installing the new shower head
, purge the pipes to remove any debris that may be in the system Before installing the
shower head make sure that the rubber washer is positioned correctly. When installing the shower head
tighten
by hand. Do not tighten too tightly. Do not use a key or pliers.
Overtightening fittings compromises
system integrity.
Utilization
This type of shower head is controlled with a simple wave of the hand.
The color of the LEDs changes automatically depending on the temperature and water
COLD BLUE - temperature
below 27°C
WARM GREEN - temperature between 27 and 41°C
RED
very hot - temperature over 41°C
