Sinclair SYMPHONY MS-H09AISW PT, User Manual

Page: 8 / 30

5
Introduction for buttons on remote controller
LCD displays“ ”. Press the button for the second time to start healthy and scavenging
functions simultaneously; LCD displays“ ” and “ ” . Press this button for the third
time to quit healthy and scavenging functions simultaneously. Press the button for the
fourth time to start healthy function; LCD display “ ”. Press this button again to repeat
the operation above.
/
SLEEP:
Press this button, can select Sleep 1 ( ), Sleep 2 ( ),Sleep 3 ( ) and cancel
the Sleep,circulate between these, after electrified, Sleep Cancel is defaulted.
Sleep 3- the sleep curve setting under Sleep mode by DIY:
(1) Under Sleep 3 mode, press "Turbo" button for a long time, remote control enters into user
individuation sleep setting status, at this time, the time of remote control will display "1hour ",
(2) Adjust "+" and "-" button, could change the corresponding setting temperature, after
adjusted, press "Trubo "button for confirmation;
(3) At this time, 1hour will be automatically increased at the timer postion on the remote
(4) Repeat the above step (2)
～
(3) operation, until 8hours temperature setting finished,
sleep,curve setting finished, at this time, the remote control will resume the original timer
the setting temperature "88" will display the corresponding temperature of last setting sleep
curve and blink (The first entering will display according to the initial curve setting value of
original factory);
control, (that are "2hours " or "3hours " or "8hours "), the place of setting temperature "88"
will display the corresponding temperature of last setting sleep curve and blink;
display;temperature display will resume to original setting temperature.
●
●
Sleep3- the sleep curve setting under Sleep mode by DIY could be inquired:
The user could accord to sleep curve setting method to inquire the presetting sleep curve,
enter into user individuation sleep setting status, but do not change the temperature, press
"Turbo" button directly for confirmation.Note: In the above presetting or enquiry procedure,
if continuously within10s, there is no button pressed, the sleep curve setting within
10s, there is no button pressed, the sleep curve setting status will be automatically
quit and resume to display the original displaying. In the presetting or enquiry procedure, press
●
●
●
Sleep 2 is sleep mode 2, that is air conditioner will run according to the presetting a group of
sleep temperature curve.
"ON/OFF" button, "Mode" button, "Timer"button or "Sleep" button, the sleep curve setting
or enquiry status will quit similarly.
:
Sleep 1 is Sleep mode 1, in Cool mode: after run for one hour in sleep mode, the
main unit setting temperature will increase 1
℃
, after 2 hours, the setting temperature will
increase 2
℃
, but the maximal setting temperature is 30
℃
, then the unit will run at this
setting temperature all along; In Heat mode: after run for one hour in sleep mode, the
setting temperature will decrease 1
℃
after 2 hours the setting temperature will
decrease 2
℃
, but the minimal setting temperature is 16
℃
, then the unit will run at this
setting temperature all along.
7
8
Press this button to achieve the on and off of healthy and scavenging functions in operation
status.Press this button for the first time to start scavenging function;
Air function is applicable for some models.