2
3
Install the rear panel
1.Always mount the rear panel horizontally.
2.Fix the rear panel on the selected location with
screws supplied with the unit.
3.Be sure that the rear panel has been fixed firmly
enough to withstand the weight of an adult of
60kg, furthermore, the weight should be
evenly shared by each screw.
Install the drain hose
1.For well draining, the drain hose should be placed at a downward
slant.
2.Do not wrench or bend the drain hose or flood its end by water.
Install the piping hole
1.Make the piping hole ( 65) in the wall at a slight downward
slant to the outdoor side. The center of the hole should be
determined refer to Fig.2.
2.Insert the piping-hole sleeve into the hole to prevent the
connection piping and wiring from being damaged when passing
through the hole.
Install the connection pipes
Electrical wiring
1. Open the surface panel.
2. Remove the wiring cover. (Fig.4)
3. Route the power connection cord from the back of the indoor unit and pull it toward the front through the wiring
hole for connection.
4. Connect the blue wire of the power connection cord to the terminal “N(1)”, the brown one to “2”, the
black
one to “3”,
and the yellow- green one ( earth wire ) to “ ” as shown in Fig.4.
Install the indoor unit
Connect the connection pipes with the relevant union pipes of the indoor unit (Shown in P25 Install the connection
pipes” ).
NOTE:
Connect the connection pipes with the indoor unit firstly and the outdoor unit secondly.
Be careful in bending the connection pipes, or you will damage the pipes.
If the tightening torque is too great in tightening the flare nuts, leakage will happen.
(Fig.3)
(Fig.2)
Summary of Contents for ASH-28AT
Page 1: ...USER S MANUAL ASH 28AT TITAN SERIES ...
Page 2: ......
