24
INST
ALL THE INDOOR UNIT
Install the rear panel
1.For well draining,make the rear panel hori-
zontally and then appreciably lower the left
side of the rear panel because the drain hose
is on the left side..
2.Fix the rear panel on the selected location with
screws supplied with the unit.
3.Be sure that the rear panel has been fixed
firmly enough to withstand the weight of an
adult of 60kg, furthermore, the weight should
be evenly shared by each screw.
Install the indoor unit
Install the drain hose
1.For well draining, the drain hose should be placed
at a downward slant.
2.Do not wrench or bend the drain hose or flood its
end by water.
Install the connection pipes
Connect the connection pipes with the relevant union pipes of the indoor unit (Shown in P26
Install the connection
pipes” ).
Install the piping hole
NOTE:
Connect the connection pipes with the indoor unit firstly and the outdoor unit secondly.
Be careful in bending the connection pipes, or you will damage the pipes.
If the tightening torque is too great in tightening the flare nuts, leakage will happen.
Electrical wiring
1.Open the surface panel.
2.Remove the wiring cover(Fig.4).
3.Route the power connection cord from the back of the indoor unit and pull it toward the front through the wiring hole for
connection.
4.Connect the blue wire of the power connection cord to the terminal “N(1)”, the brown one to “2”, and the yellow- green
one ( earth wire ) to “ ” as shown in Fig.4.
5. For the heat pump type, connect the control cord ( 4
0.75) to the indoor unit through wiring interface shown in Fig.4,and
clamp the connected cord on the chassis.
1.Make the piping hole ( 55) in the wall at a slight
downward slant to the outdoor side. The center of
the hole should be determined refer to Fig.1.
2.Insert the piping-hole sleeve into the hole to pre-
vent the connection piping and wiring from being
damaged when passing through the hole.
６６１２２４５２．ｐ６５
03-7-15, 17:26
24