SCULPTURA SOUNDPAD
Powered Soundpad / Barre de son
www.sinclairaudio.com
BT = Bluetooth
OP = Optical
IN = RCA
MI = 3.5mm Input
Soundpad Input Names
Placing the soundpad on a flat surface
If your TV is placed on a flat surface such as a TV stand or another
piece of furniture, center it as much as possible with the TV screen.
Attach the supplied rubber pads to the bottom of the to prevent
scratching the furniture.
Positionnement de la barre de son sur une surface plate
Si votre téléviseur est placé sur une surface plate tel un socle de téléviseur
ou tout autre meuble semblable, centrez la barre le plus possible en rapport
avec l’écran du téléviseur. Fixez les coussinets en caoutchouc sur le
dessous de la barre de son pour éviter d’érafler le mobilier.
Soundpad Placement / Placement du barre de son
FT = Flat ( first two digits show inputs, second two digits shows EQ )
MU = Music
CM = Cinema
CV = Clear Voice
3D = Wide Sound
Soundpad EQ Names
Minimum Volume = ( First two digits show inputs, second two digits
shows volumes)
Maximum Volume
If the Volume is 60, and you pstill press the “VOL+” button, the dis-
play will show
Soundpad Volume Range
If the soundpad is connected to the AC Power and you did not press
the “POWER” button on the remote control or on top of the panel,
the isplay will show one dot which means it’s on standby.
These dots indicates 3D ON
If
MIC.V.
is shown, that’s means the 3D and Clear Voice is ON.
If
MIM.U.
is shown, it means that the 3D and Music is ON.
If
MIC.M.
is shown, it means that the 3D and CINEMA is ON.
If
MIF.T.
is shown, it means that the 3D and FLAT is ON.
If
MI3d.
is shown, it means that the 3D is OFF.
If
MICV
is shown, it means that the 3D is OFF but Clear Voice is ON.
If
MIMU
is shown, it means that the 3D is OFF but Music is ON.
If
MICM
is shown, it means that the 3D is OFF but Cinema is ON.
If
MIFT
is shown, it means that the 3D is OFF but Flat is ON.
Soundpad dots and its Purpose
First, press the “learning” button, the display showed “LRN” and
flashed at 0.5s frequency.
And press the button on another remote which you want to set up,
“LRN” showed on display will stopped flash when receives remote
code.
Press the relative button on top control panel which have allocation
function for remote button, the display show “OK”
If press this button to 6S, it will make the remote initialized to facto-
ry settings. Exit learning function if press “learning” button when
the display is in flashing status. Please notice that the learning
function can only identify NEC format’s remote control.
Soundpad Learning Functions
