Sinbo SHD 7077, Instruction Manual

Page: 4 / 13

- 3 -
malfunction is detected or after it was dropped, unplug the unit and apply to any authorized
service center at the contact addresses given in the warranty certificate/
• To avoid damages, transport the unit in the original package only.
• Keep the unit in a dry cool place away from children and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE ONLY, ITS COMMERCIAL USAGE AND
USAGE IN PRODUCTION AREAS AND WORK SPACES IS PROHIBITED.
BEFORE THE FIRST USE
After unit transportation or storage under cold (winter) conditions, it is necessary to keep
it for at least 3 hours at room temperature before switching on.
– Unpack the unit and remove any promo-stickers that can interfere with the unit
operation.
– Check the unit for damages; in case of damages do not use the unit.
– Before switching the unit on, make sure that your home mains voltage corresponds
to the unit operating voltage.
USAGE
To get the best results, wash your hair with shampoo, wipe it with a dry towel, dry with
a hairdryer and comb your hair. After that you can start styling your hair.
– Divide the hair into locks 4-5 cm wide.
– Put the unit on the safety stand on a flat heat-resistant surface.
– Insert the power plug into the mains socket.
– Turn the temperature control knob and set the required heating temperature of the
operating surface (see the table).
– Switch the electric tongs on by setting the power switch to the position «1», the light
indicator will light upand start flashing. After the set temperature is reached, the indicator
will glow constantly.
Hair type Temperature
For fine hair, sensitive to high temperature Temperature from +130°C to +150°C
For normal wavy hair of medium thickness from +150°C to +170°C
Hard, thick, curly hair from +190°˚C to +210°C
Note: While setting the temperature, remember that the operating surface heats up fast
but cools down much longer.
– Take a hair lock with the free hand.
– Press the clamp handle, place the end of the lock on the operating surface and move
the clamp down.
Holding onto the protecting tip and handle, wind the lock around the operating surface.
– Wait for a while, then press the clamp handle and release the hair lock.
– Repeat this procedure on the rest of your hair.