Sinbo SFH 6927, Instruction Manual, Page: 4 / 12

- 3 -
1
2
3
OPERATION OF THE HEATER
NOTE: It is normal when the heaters are turned on for the first time or when they are
turned on after having not been used for a long period of time the heaters may emit some
smell and fumes. This will disappear when the heater has been on a short while.
OVERVIEW
1. Temperature control
2. Rotary switch
3. Safety tip over switch
OPERATION
1. Carefully remove the Heater from the plastic bag and the carton.
2. Place the heater on a firm level surface.
3. Set the main power switch to ‘‘
’’. Plug the cord set into a 220-240V~ electrical outlet.
Turn the main temperature control which at the back cover to ‘+’ position the Heater will
be operated normally.
4. Turn the power control to “
” mode, and blow the cold air.
5. Turn the power control to “I” mode, the unit will be in the low heat mode. The power
is 750W
6. Turn the power control to “II” mode, the unit will set the Heater into high heat model.
The power can be reach 1500W.
7. Turn the power control to “0” mode and temperature control at back cover to “-”.
SAFETY FEATURES
1. A thermal overload protector is built in to prevent overheating.
2. When an overheat temperature is reached, the Heater will be automatically shut off.
It can only resume operation when the user resets the unit.(See reset instructions below)
To Reset Heater:
1. Unplug the Heater and wait 5-10 minutes for the unit to cool down.
2. Then, turn on the unit again and operate normally.