E Q U O B O X R T U - M o d B u s
–
U s e r G u i d e R e v . 2 . 2
S I N A P S I S . r . l . |
V i a d e l l e Q u e r c e 1 1 / 1 3 - 0 6 0 8 3 B A S T I A U M B R A ( P G )
–
I t a l y
T . + 3 9
0 7 5 8 0 1 1 6 0 4
- F . + 3 9
0 7 5 8 0 1 4 6 0 2 |
w w w . s i n a p s i t e c h . i t
i n f o @ s i n a p s i t e c h . i t
17
9.
CONNECTING THE RTU TO THE PC
Connect the RTU either to ETH1 or ETH2 using a T568A or T568B (straight through or crossover) Ethernet cable
as shown in Figure 12
Figure 12 - LAN connection
Set the network adapter of your PC in such a way as to allow communication between the two devices. Below
is a description of a possible configuration of the LAN between the two devices in the event that the RTU IP
address has not been changed, as shown in Chapter 5.3, 8.3
Carefully read the following notes
In order for the RTU and PC to communicate, the two devices must have an IP address within the same subnet.
The default RTU network settings are:
•
IP address:
192.168.1.110
•
Netmask:
255.255.255.0
•
IP allocation:
Static
In order for the computer to communicate with the RTU via Ethernet, the IP address of the computer’s network
adapter must be set as follows:
•
IP address:
192.168.1.XXX (With XXX being a number ranging between 1 and 254 and different than 110)
•
Netmask:
255.255.255.0
•
IP allocation:
Static
To change the IP address of your computer’ network adapter, refer to its Operating System user guid
e.
In the event that the PC and the RTU are connected via an existing LAN (company or domestic network),
make sure not to allocate the IP address of the RTU or of the PC.
In the event that the default IP address of the RTU has been changed, you can consult the current IP address
as described in Chapters 5.3, 8.3.
