Thank you for purchasing our F1 LC Pedal Set. We are sure you will enjoy your purchase.
The compact design of the F1 LC Pedals makes it suitable for fitting in to compact F1 style cockpits where footwell
space is limited.
The Pro Series range of controls are products that were designed and developed by SimworX with the ultimate aim of
supplying the most realistic motorsport inspired controls for the ultimate virtual racing experience. Each product is
pre-tested prior to shipping to ensure your investment is ready to go once you’ve received it. We continually upgrade
our controls to ensure the pedals are robust and give positive feel and feedback. A 12 bit resolution USB interface
ensures accurate pedal control whilst the unique Hydraulically loaded Load Cell activation system enables the braking
system to be fully tuned in to your racing style.
A load cell works the way it feels. It is measuring force (same as a brake) and feels like a brake because it gets
harder to get it to "max" due to the progressive resistance that gets harder and harder. The perfect pedal for sim
racing is to have hydraulics in the system because that's what real brakes are, and in conjunction with the load cell,
the force outputs to a 12 bit resolution circuit board for accuracy. Simworx has also introduced a rocker arm that the
load cell cylinder system pressures up, and by introducing variable durometer dampers that works against the rocker
arm’s action, a very finely tuned end stop feel can easily be attained. In a good race pedal system, the pedal barely
moves once the pads touch the rotor. A good racecar brake pedal feels like stepping on a brick once full pad pressure
has been attained and that is achievable with this system. If that’s not to your liking, you can back it off by using the
thumb screw and/or interchanging the supplied dampers. Brake feel is very subjective, that’s why all of these
adjustments have been introduced.
The following instructions will guide you through the installation process and the various adjustability options
built into the unit
1x Pro F1 LC Pedal Set
1x 3M USB Cable
3 x Urethane Load Cell Rocker Arm Bushes
1x Stainless Steel Bolt Pack with Alloy Washers
1 x Allen Key Set
For owners of existing Simworx simulators and/or chassis units, the mounting points for the pedals are already in
place. Locate the pedals and with the supplied bolt set insert them in to the pre-tapped bolt holes. .
For fitting to other simulators, make sure the frame is strong enough to withstand the forces you can exert on the
brake pedal. On the next page you will find a drilling guide for your Pedals base plate. Position the pedal set plate at
your preferred location and using the rear slots either side of the base plate, carefully mark the hole position through
the rear base slot onto your mounting surface. As a rule we usually recommend marking the mounting bolt holes
halfway in the slots so you can move its position backwards and forwards to your requirements.
Once you are satisfied with its location, drill a small pilot hole at each bolt location. Finish the hole size for the
forward slots at 8.5mm
Bolt the pedal set in place using two of the supplied bolts and alloy cup washers in the bolt pack. Loosely fasten the
slot bolts and adjust the pedal position incrementally until you are satisfied with its final position. Once satisfied mark
through the two bolt holes on the front slots, take the pedal set off again and drill the final two 8.5mm holes where
you marked them.
For final permanent mounting, push in the four slot bolts and tighten securely. Please make sure they are secured
tightly to ensure that the pedal set doesn’t flex under the pressure. The mounting surface needs to be strong enough
to withstand the of pressure that can be exerted on the brake pedal. Any flex in the mount plate will affect
the pressure exerted on the Load cell.
INTRODUCTION
PACKAGE CONTENTS
FITTING
